Lightning Current Arresters
FLP-275 V/3+1
FLP-275 V/3S+1
SPD type 1 and type 2
Replaceable module, visual fault signaling
Combination of 3-pole varistor surge protection and an encapsulated spark gap connected in the mode 3+1. To be installed in low-voltage distributions at the boundary of LPZ 0B and LPZ 1 zones to protect distributions and equipment against the overvoltage effects induced during a lightning strike and to
prevent switching overvoltage. Optional remote status signalling (S).
Technical data | L-N | N-PE |
Nominal voltage Un | 230 V AC | ------ |
Maximum operating voltage Uc | 275 V AC | 255 V AC |
Nominal discharge current (8/20 μs)/pole In | 30 kA | 20 kA |
Maximum discharge current (8/20 μs)/pole Imax | 60 kA | 40 kA |
Lighting impulse current (10/350 μs)/pole Iimp | 8 kA | 25 kA |
Voltage protection level Up | 1,2 kV | 1,5 kV |
Response time ta | 25 ns | 100 ns |
Ability to independently switch off the following current Ifi | no following current | 100 A |
Short-circuit proof at maximum overcurrent protection | 35 kArms | -------- |
Maximum overcurrent protection | 160 A gL/gG | -------- |
Degree of protection | IP 20 | IP 20 |
Range of operating temperatures | – 40 °C … + 80 °C | – 40 °C … + 80 °C |
Mounting on | DIN rail 35 mm | DIN rail 35 mm |
Cross-section of connected conductors Solid min/max Stranded min/max |
ISO: 1/50 mm2 ; AWG: 17/1 ISO: 1/35 mm2 ; AWG: 17/2 |
ISO: 1/50 mm2 ; AWG: 17/1 ISO: 1/35 mm2 ; AWG: 17/2 |
Stripping length of the supply conductor | 14 mm | 14 mm |
Tightening torque | max. 4 Nm | max. 4 Nm |
Fault indication | red indication field | no |
Remote indication – S design | potential-free change-over contact | --------- |
Remote indication contacts | 250 V / 0,5 A AC, 250 V / 0,1 A DC | --------- |
Cross-section of remote indication conductors | max. 1,5 mm2 | --------- |
Meets the requirements of standard | EN 61643-11 + A11T1T2 | EN 61643-11 + A11T1T2 |
Ordering number FLP-275 V/3+1 FLP-275 V/3S+1 |
8595090531128 8595090531135 |
|